Need Aftermarket Storage Solutions for Cargo Area

[demack6]

Not a lot of space. 2 1/2 inches.
If you replaced the board with plywood/MDF and had a support in the middle, you could get another inch. The board is a hard foam that is quite thick. I didn't measure, just going by looks.

Sponsored

 

[Maximus4R]

Here are the stl files.
I have included two files for the bracket. One with a simple hole and the other with a slot. The screw is okay if you print it horizontally. You may have to chase the threads with a die depending on your printer setup.

If you don't trust the screw, source one on amazon or get a wing-bolt and use the bracket with the hole.

Amazing, thank you!