If it’s any help, I used the standard rhino ramps to do an oil change and had no issue with it.
Sponsored
Sponsored
How're you lifting your 4runner? Ramps or floor jack + jack stands?
- Thread starter
- #17
After seeing your pictures, I went to Harbor Freight and picked up a set of plastic ramps. Once I get a jack and jack stands, I’ll start doing my own oil changes. Thanks!If it’s any help, I used the standard rhino ramps to do an oil change and had no issue with it.
I use the Harbor Freight Daytona jack with Husky 6T jack stands.
For oil changes, I use the Pittsburgh creeper to slide under and remove the skid plate.
I use the jack to lift at the front crossmember to put the skid plate back.
For tire rotations, since I rotate in the spare, I only need to jack at each corner to lift that wheel at a time. Hope that gives you some ideas
For oil changes, I use the Pittsburgh creeper to slide under and remove the skid plate.
I use the jack to lift at the front crossmember to put the skid plate back.
For tire rotations, since I rotate in the spare, I only need to jack at each corner to lift that wheel at a time. Hope that gives you some ideas
Sponsored
