Search results

I had this issue using 3M VHB to mount my radio in the passenger footwell. That stuff should be more than sufficient, but the texture on the interior panels makes it hard for tapes to stick. You could theoretically sand down the panel a little bit, but that’s not something I personally would...

Yeah exactly this seems like something that’ll be a problem in these cars 10-15 years down the line

i did watch a couple, but wasn’t quite sure what I was looking at. Thought I’d consult the expert advice of the fine folks in this forum, but thanks for your comment.

Got it, so going with Meso customs would basically be my only option then. thank you so much!

Hey Everyone, I’m looking into solutions to improve all the interior lighting throughout the car (map, dome, cargo, etc.) I’ve seen plenty of threads about Meso installations, but I’m not looking to go this route at the moment. To anyone who might have done the Meso installation though, are...

BF Goodrich KO2s. 285/70r17

I’d still like to take a look, seems like it could still be a feasible option. Thanks!

Put on the light bar last night, went to sleep, and then drove straight to work 😢

would you share where you purchased them?

I’d be very interested to hear more about the internal molle system and the price point on it

Hey everyone, I installed an Auxbeam RA80 in my 4Runner this weekend, and as a complete novice in automotive wiring, I couldn’t find a comprehensive guide on this install that answered all my questions. Hopefully, I can cover those details in this thread. 1. Mounting the control box I mounted...

The primary bane of my existence this weekend was installing an auxbeam switch panel. I’ll do a comprehensive write-up on that with everything I wish I knew before starting and couldn’t find clear answers to on the internet. Then hooked up a set of Cali Raised ditch lights and a Midland GMRS...

Installed a set of OEM trailhunter rock sliders courtesy of @BadTrainDriver I also installed a set of front and belly skid plates from Rough Country.

steps are off and ready to go

This thing is solid for sure. Myself and 2 of my buddies climbed up onto it, and it held the weight without hesitation. You can rock the car back and forth from the rack as well. I haven’t noticed any play at all. My assumption would be that it will have no issues with your application, and I...

The crossbars have been removed from the vehicle. Bumping this thread for visibility.

Finally got nice enough weather to install my Prinsu original roof rack

Thanks for this info, that was very helpful! So maybe I’m thinking about this wrong… Let’s say I have an accessory drawing 2.25 amps, and it’s hooked up to a 20amp fuse. That would mean that the circuit wouldn’t shut down until it’s allowing 20 amps of current. Let’s say something were to go...

Hey all, I recently purchased an auxbeam RA80 switch panel and am looking to wire my lights and other accessories to the panel. I had a question regarding fuse selection that I’m hoping you folks would be able to answer. the auxbeam panel comes with fuses sized 30, 20, 10, and 5amp. Let’s say...

I can’t exactly speak from experience, but I do have the original Prinsu rack waiting in my apartment for a warm enough day to install it. I bought the rack specifically for a rooftop tent. Its dynamic load capacity is 700 lbs and the static load capacity is 1200 lbs. So essentially, as long...