Sponsored

TPM on dash question - tire pressure shows dashes only

2025 Big Red

TRD Off-Road Premium
Well-known member
First Name
Ron
Joined
Apr 18, 2025
Threads
9
Messages
78
Reaction score
50
Location
Arizona
Vehicle(s)
4 Runner 2025
When I start Big Red, the tire pressure display for the 4 tires and spare pops up. However, it’s just dashes.
Doesn’t display the pressure. Is there a setting I need to reset?
Sponsored

 
OP
OP
2025 Big Red

2025 Big Red

TRD Off-Road Premium
Well-known member
First Name
Ron
Joined
Apr 18, 2025
Threads
9
Messages
78
Reaction score
50
Location
Arizona
Vehicle(s)
4 Runner 2025
I guess I didn’t ask question correctly. I get a dash display showing all five tires but no pressure is displayed. Is there a setting I need to change so it will display tire pressure. Yes, I can see tire pressure on app..
 

jblack

TRD Off-Road Premium
Member
Joined
Mar 10, 2026
Threads
0
Messages
15
Reaction score
6
Location
Canada
Vehicle(s)
2026 4runner
I guess I didn’t ask question correctly. I get a dash display showing all five tires but no pressure is displayed. Is there a setting I need to change so it will display tire pressure. Yes, I can see tire pressure on app..
If the vehicle engine is started the pressures will appear after a couple of minutes the vehicle doesn't have to move
If you need to add air it takes a couple of minutes to display the new pressure
Good idea check tires with a pressure guage and compare to what the tpms displays
I have found they read about 1 psi lower than guaged pressure
 
Last edited:

MikeD

TRD Off-Road Premium
Well-known member
Joined
Jun 4, 2025
Threads
12
Messages
461
Reaction score
343
Location
Virginia
Vehicle(s)
2025 4Runner TRD Off Road Premium - Heritage Blue Hybrid
Odd that you are seeing psi on app but not dash
Maybe looking at wrong set? Try switching sets and driving for a while.
To swap between sets: Settings -> Vehicle Settings -> TPWS Setting -> Tire Set Switching -> Register Valve/ID. Select the Set: Use the meter control switches to select the set that corresponds to the wheels currently on the vehicle ("Tire Set 1" or "Tire Set 2") and select OK.
The change takes a short time driving to show up on the TPMS power measurements on the dash. Note the difference: "register new valve/ID" vs "register valve/ID."
Not sure this is your issue but maybe??
 

127.0.0.1

SR5
Well-known member
Joined
Oct 9, 2025
Threads
4
Messages
602
Reaction score
499
Location
earf
Vehicle(s)
a bunch of Toyotas
If the vehicle engine is started the pressures will appear after a couple of minutes the vehicle doesn't have to move
<snip.
yes no need to drive when it is all working and registered

but when there is a fault, system needs a full reset (change wheel)
you do need to drive around after that (typically) so system can register
the 'closest sensors' and sort them out from other radio interference, and also locate the positions
 
OP
OP
2025 Big Red

2025 Big Red

TRD Off-Road Premium
Well-known member
First Name
Ron
Joined
Apr 18, 2025
Threads
9
Messages
78
Reaction score
50
Location
Arizona
Vehicle(s)
4 Runner 2025
By George, I think you hit the nail on the head.
I’m also experiencing the low tire pressure light on dash has been on for about two weeks. I run tire pressure at 35psi. Verified by app tire psi, electronic hand/manual gauge and Milwaukee M18 compressor.
 

127.0.0.1

SR5
Well-known member
Joined
Oct 9, 2025
Threads
4
Messages
602
Reaction score
499
Location
earf
Vehicle(s)
a bunch of Toyotas
SR5 doesn't have TPWS in spare and display doesn't have a position for 5th sensor

if your display shows 5 possible pressure readouts it came with TPWS in spare
 

spelingbeachampeun

Trailhunter
Active member
Joined
Nov 19, 2024
Threads
2
Messages
33
Reaction score
50
Location
Michigan
Vehicle(s)
2020 Navigator, 2014 MDX, 1993 Taurus SHO
If you’re seeing dashes you should just need to give it time to register. Mine shows dashes in all five positions after each startup until it registers what the pressures are. Sometimes it registers fairly quickly, other times it takes 3-5 mins of driving after a tire rotation for example.

I am just assuming the app will show the last measured pressure, not exactly real time.

if you’re seeing the tire pressure light (which may also indicate high pressure not just low) you can adjust those settings in the cluster settings. Your warning may be set too high or low.
 
OP
OP
2025 Big Red

2025 Big Red

TRD Off-Road Premium
Well-known member
First Name
Ron
Joined
Apr 18, 2025
Threads
9
Messages
78
Reaction score
50
Location
Arizona
Vehicle(s)
4 Runner 2025
I’m going to work on it today after some trout wishing in the White Mountains of AZ.
 

BruceB

TRD Off-Road Premium
Active member
First Name
Bruce
Joined
Dec 5, 2025
Threads
0
Messages
26
Reaction score
9
Location
Washington
Vehicle(s)
Chevy Silverado Z71, 4Runner TRD ORP Hybrid
I guess I didn’t ask question correctly. I get a dash display showing all five tires but no pressure is displayed. Is there a setting I need to change so it will display tire pressure. Yes, I can see tire pressure on app..
The app is not always current. I just opened my app and it said my tire pressure was last updated 23 hours ago.

2025 2026 4runner 6th gen TPM on dash question - tire pressure shows dashes only IMG_7178
Sponsored

 
 







Top