Sensors not working after leveling kit install

[TRDLE]

We installed the Westcott leveling kit along with new wheels/tires and had an alignment done. The alignment shop (highly recommended and this is all they do) mentioned that they would reset the sensors as well. The alignment was done without issue.

However, once they went to reset the steering angle sensor, things went south and about 8 safety sensors popped up and they couldn't get the issue resolved.
-TPMS
-Secondary collision
-VSC
-Brake system
-Advanced Ultrasonic Detection
-ECM
-ABS
-Check engine light
-Drive-start control

Also, their code reader pulled up a code C1345 which is for the linear solenoid valve offset. They ran through the offset learning process with no success in clearing the code.

Does anyone have any insight/resolution for this or know what the problem could be?
I have an appt at the dealership on Thursday and would like to be the best informed to make sure they don't try and pull a fast one on me.

Sponsored

 

[Desert_6Gen]

Did you try disconnecting the battery for 20 minutes to see if that clears it? Does it let you clear the codes or does it always stay on? If you do bring it to a shop; I wouldn't suggest the dealer. Any independent shop can do this without paying twice as much at a dealer.

 

[TrdProGirl84]

I had my Westcott Preload Collar lift installed professionally. No issues with the install. Hopefully you get it figured out.

 

[127.0.0.1]

sounds like they use a scan tool that doesn't have the correct
mapping to set up your model. or they didn't plug everything back in snugly

Sponsored