TRD Pro/Trailhunter Heritage Grille Swap (Upper & Lower Grill) on SR5, with part numbers

[Maximus4R]

I'd put a sizeable wager on there being a 12v and ground that'll fire that puppy up. That's all I need to find. If I can get a factory connector to pin into, that would just be cake on top of my cake.

That’s my hope as well. If you can get it to turn on we’re in business with some relays and wiring. I’d freaking love an OEM connector though. I made some aux switch harnesses but was able to get pins easily, these look a little crazier though.

Sponsored

 

[Dead Horse]

That’s my hope as well. If you can get it to turn on we’re in business with some relays and wiring. I’d freaking love an OEM connector though. I made some aux switch harnesses but was able to get pins easily, these look a little crazier though.

I don't even need a relay (I don't think). I have the factory aux switches. So I think that as long as I can get the amp draw, it should be a two-wire solution for me. Unless I'm grossly misreading the aux-switch instructions, which is entirely possible LOL

 

[Dead Horse]

Got the light bar in today. It's in great shape, but I'm a little disappointed that there's no part number on it LOL

Here are a couple of slightly better pics of the connector.

 

[Maximus4R]

Nice! What do we think the smaller pins are for? Something with the factory high beam reqs? I figured that would be handled up stream but who knows. What are next steps? We feed this thing 12Vs!?

 

[Dead Horse]

Not sure. I only had a few minutes to peep it out and two of the small pins have a closed circuit to one of the large posts (with no power to it)...I was just checking for connectivity though. Haven't put 12v to it yet. I don't know when I will either. This month is busy, and I'm absolutely waiting for a warm day LOL

Sponsored