Exterior MOLLE Panels compatible with stock Trailhunter Roof Rack

[1Volfan]

So here are these, done, but i find that the gas pack locs are short (photo red can, just placed not tightened) for 3 gal rotopax, the base height is 2 inches i think it needs to be longer, (just ordered one link below) This one is good with 2 gallon Rotopax.
Although the base that is square is messing up the gas can see the photo of green can. (correction here, happens to be i didn't know how to close and lock the mount, i learned it by messing up my canister).

For the Maxtrax the rack and mounting it on ARB 3/4 rack 2026 4Runner Trailhunter. I NEED HELP.

My rack currently has four T-slot / T-track channels installed (image attached for reference). However, I can see a fifth position on the rack where an additional slot appears it could be installed. When mounting my Maxtrax using the Narrow Bridge Plates, I am coming up short and an additional slot would solve the mounting spacing issue. (see attached image)

Could you please confirm:
Is the rack supposed to come with only four T-slots from Toyota, even though there appears to be space for five?


Not sure if you’ve seen this thread, but answers to your question about the slots here:

https://www.4runner6g.com/forum/thr...the-arb-3-4-roof-rack.5145/page-3#post-112611

Sponsored

 

[Gagi]

Thanks I didn’t see it. But I called Toyota. That’s how it is.