Installing the Rago center mount rear bumper…found out a little too late that there is a missing part in their install guide.

[FlaRunner904]

I’m not sure what it is honestly but I’m pretty sure it’s the kick sensor for the ORP. . Can anybody confirm this for me? I can’t find a pic of it anywhere.

Sponsored

 

[baole0127]

Yup, I think that what it is also. Kick sensor, I throw it in the trash. The dam thing never work right for me any way.

 

[FlaRunner904]

Yup, I think that what it is also. Kick sensor, I throw it in the trash. The dam thing never work right for me any way.

Haha yea guess thats prob gonna be what i do. It was nice while it lasted. Still gonna see if i can rig it up somehow.

side note. What lights dod you get? And how hard was that wiring job?

 

[baole0127]

I got the Baja S2 sport. It’s not too bad. Wire them up to the Aux switch. Take some of that empty slot out. Look a little less poor

 

[FlaRunner904]

I got the Baja S2 sport. It’s not too bad. Wire them up to the Aux switch. Take some of that empty slot out. Look a little less poor

haha yea that’s my plan. I got my lightbar set up that way. Did you connect to battery? And how did you get your wires down there?

 

[baole0127]

haha yea that’s my plan. I got my lightbar set up that way. Did you connect to battery? And how did you get your wires down there?

yeah I hook everything to the battery, the front and the back lights. There’s a through hole from both side of the wall that you can run your wires in. If you going on YouTube and looking up the installation of 2024 tacoma ditch light from Cali raise, it’ll help with the wiring.

 

[HVLA]

The kick sensor is a useless gimmick. We never use ours.

Sponsored