Trailhunter Lower Grille Part Numbers?

[Russ]

Didn’t have any problems with the my 4runner putting it back, snapped back into place without any issues.
Hey, more reasons to drink beer, right?
Also, you might want to get the light bar bracket from Raveoffroad. Helps in mounting the light bar easily. Cheers!

Sponsored

 

[CMill4Runner]

Didn’t have any problems with the my 4runner putting it back, snapped back into place without any issues.
Hey, more reasons to drink beer, right?
Also, you might want to get the light bar bracket from Raveoffroad. Helps in mounting the light bar easily. Cheers!

Great minds think alike, yes I did the same Rave brackets on mine, actually that was the only hold up in shipping I had. I think my issues were around the assembly being slightly and mean slightly to the driver's side, the pass side didn't want to snap in.

 

[Xhale760]

did you guys go with rave light bar or RC light bar?

 

[Russ]

Got Heretic on mine.

 

[df525]

did you guys go with rave light bar or RC light bar?

Just some note for the RC light bar. I tried 20inch RC DRL light bar, but end up returning it. It was about 1/4 inch too long to fit into the Grill and the Rave universal bracket was too short for it. Also the DRL version of the RC requires a different power setup, a 3 position switch instead of on/off.

 

[Xhale760]

Great I just ordered one lol... What brand is a direct fit?

 

[Maximus4R]

I just ordered the rave universal bracket and rough country light bar. I’m assuming the three position switch is just to keep the backlight and primary separated at the switch. When I ran rough country lights a few builds ago I never had an issue tying the backlight into my DRLs with the primary on a standard switch.

 

[Xhale760]

I just ordered the rave universal bracket and rough country light bar. I’m assuming the three position switch is just to keep the backlight and primary separated at the switch. When I ran rough country lights a few builds ago I never had an issue tying the backlight into my DRLs with the primary on a standard switch.

I got the same setup waiting for it to arrive hopefully it fits

 

[Maximus4R]

I got the same setup waiting for it to arrive hopefully it fits

Not blaming Rave but I don’t think they should advertise the rough country bar as fitting without modifications. Maybe it’s the same for other bars, but side mounting stubs stick out beyond the oem front grill space, meaning you have to have it set back 1/4” or so. I ended up notching mine but it’s not perfect and driving my OCD a little nuts. I’m also spoiled coming from some diode dynamic MAX stuff… so there’s that. I ended up using two sets of rough country fogs to replace the oem fog lights. I 3D printed a bracket, might not be the best but I think it turns out great. Whites run on the factory fog switch with the yellows tied into Aux 2 on the OEM switches I added.

Sponsored