Molle panel

[rajib77]

Hello,

Anyone using this Molle panel? I would like to hear your thoughts.

https://a.co/d/05pqIT3b


Thanks.

Sponsored

 

[EL616]

I don't have them but like the idea of side panels that don't require a full aftermarket roof rack. It looks like you have to move the rear crossbar up like a full foot to fit them though -- as someone who uses my crossbars a lot that's a no-go for me. Looks goofy and I doubt it's safe to roof-top anything long or heavy with them that close together.

If you don't use crossbars much then no biggie, but otherwise I'd go with these from Rago. They left spaces at the top so you can still keep your crossbars spaced properly.

 

[MartyMcFly]

I have been eying those myself.

 

[rajib77]

I don't have them but like the idea of side panels that don't require a full aftermarket roof rack. It looks like you have to move the rear crossbar up like a full foot to fit them though -- as someone who uses my crossbars a lot that's a no-go for me. Looks goofy and I doubt it's safe to roof-top anything long or heavy with them that close together.

If you don't use crossbars much then no biggie, but otherwise I'd go with these from Rago. They left spaces at the top so you can still keep your crossbars spaced properly.

Fully agree. Infact, I think I need to drill holes too. I checked and no holes at that position. Holes are slightly behind that and will be covered by molle panel clamp. But I don't use my cross bars at all. Rago is perfect but 2.5 times the cost. That's why I was considering this.

 

[sliver]

The description states specifically not for the trailhunter... Siiiiigh... I hope you guys enjoy, I'm starting to look at Prinsu and Westcott...

 

[rajib77]

The description states specifically not for the trailhunter... Siiiiigh... I hope you guys enjoy, I'm starting to look at Prinsu and Westcott...

Technically it is not a good fit with factory crossbars too. It will only fit perfectly without any crossbars.

Sponsored