26 ORP Hybrid Baja Designs Fog install

[MARK4A3]

I am currently planning to install the BD fog pocket brackets.
Because I’m extra, I will be wiring:

-Pair S2 Sports to the factory fog wires.
-Pair S2 Pros to AUX4
-And when I get brackets, ditch light position Squadron Sports to AUX3

To make the set up easier to service, I will be using the BD 2 pin connectors on the LO pigtail. I cannot think of what to use for the AUX5 (on with car) connection.

I will try to post pictures of the brackets with the lights installed.

I really only want to pull off the front bumper once so any tips on how to orient the lights onto the fog adapter bracket are welcome.

How have you aligned the lights?

Sponsored

 

[MARK4A3]

LO AUX pigtail now set up for install.
I thankfully had a lot of leftover plugs allowing me to pin the correct leads.

The AUX5 wire was just folded and hidden in that plastic conduit stuff.

Had to solder a split on the ground wire.

 

[Dead Horse]

You're doing two sets of fog lights?

What's "Aux 5"?

 

[Twisted]

For what it is worth I used the Westcott Designs mount for my fogs. In my opinion it is a much cleaner finished off look and takes away any guesswork on mounting/aiming.

 

[MARK4A3]

You're doing two sets of fog lights?

What's "Aux 5"?

Yes, sports to the fog switch with the combo driving lens.
Pro controlled by AUX4

The book says AUX5 is just on whenever vehicle is on. I can’t think of what to hook to that.

 

[MARK4A3]

For what it is worth I used the Westcott Designs mount for my fogs. In my opinion it is a much cleaner finished off look and takes away any guesswork on mounting/aiming.

That is definitely sexy.
As much as I hate it, I’m gonna remove the front bumper again. Once I have the bezel off, I’ll loosely hang the bumper on the runner so I can do some aiming and centering of the assembly

Sponsored