Search results

LOL I had the same question. Excessive safety-ism strikes again.

very cool. can you give an idea of the cost?

The front diff and transmission are already vented high in the engine compartment. You'll want to add a breather to the rear diff though. I bought an ARB breather kit for my TH, haven't installed it yet.

No relocation, no control pack, all controls came with

Ice Cap + Aurora Long Island NY

Ice Cap + Aurora Long Island NY

cool stuff!

I think that's just an odd angle which you wouldn't normally see. I'm crouched down to show the ports in the bumper and the oem skid plate. You're looking out through the bottom/side which is back-lit by the garage lights. You can see it through the stock grille up 6" higher as well. Sure...

There was nothing to install. The wireless works OOTB. You can see me using the wireless remote at 42:45 to extend and retract the line. You can access the clutch through the cut-out (HIgh lift jack port?) on the right side of the fairlead. In the picture below, you can see where it says...

updated with part 2

OK I made a thread. Posted the electrical pre-install; Will post the bumper part in a follow-up as soon as I edit it. Strictly to help a brother out. https://www.4runner6g.com/forum/threads/cbi-stealth-bumper-warn-evo12s-2025-trailhunter-install.7257/

Here's part one; Electrical pre-install. Be kind please. 1.5x speed is probably OK Here's part two: Actual bumper and winch install. I tried to do more editing/speed up of boring parts. And many thanks to everybody who posted similar install videos before me. You inspired me to record...

i just installed one and videoed most of it but i haven't had time to edit everything yet. is there a certain part where you're stuck? i can DM it some clips. i can reach the controls through the bumper from the outside.

The missing crossbar from the 3/4 ARB rack? I have an extra one still in the shipping tube (accidentally ordered 2). You can have it for free. You create UPS shipping label and send to me.

Pictured: CBI Covert Superstock Bumper WARN VR EVO 12-S winch OEM 4R/Taco recovery hooks Baja Designs XLR 80 Ditch Lights Starlink Mount 2x Yakima High Road Bike Rack Front Runner Verical Surfboard Carrier

did it work?

you have no idea what you're talking about. lots of taco owners and owners of other 4x4s with snorkels do this. not invented here. airflow passes around the edges of a sponge plug inside the snorkel because the sponge is porous and not a perfect seal. it fits snugly but does not block the...

Tough break. Try one of these, it does help. Remove the two phillps head screws on the protective louvered screen/grille and then it'll pop right out when you pull on it. Push your sponge inside the snorkel tube about 1–2 inches down so it can't be seen but not so deep that you can’t remove...

My stealth bumper is en route. Do you have the video mentioned in the PDF?

i don't know the answer since i only have the one truck, but i did not hear ESE either until i turned it off. the dealer can also turn it off for you, if it's a feature of the ORP