Search results

https://www.etsy.com/listing/4383520125/?ref=share_ios_native_control

I would visit etrailer.com and pose the question on the revert product page. They’re really good about answers and work-arounds

I recommend the seat jackets. Made a big difference for me

Interesting! Pretty inexpensive…worth a try I’d say. I wonder how the upslope of the folded rear seats would affect comfort.

Why didn’t I think of that? A magnetic mount could work as well.

"Roof load capacity: 770 lbs. static, 165 lbs. dynamic"... " the new 4Runner offers a 770-pound static roof load capacity, which is perfect for a rooftop tent (RTT). However, the roof’s dynamic capacity is only 165 pounds,

Wondering this myself. Perhaps awning brackets could be made to wotk

These look like an interesting alternative: https://kingpinequipped.com/products/kingpin-v1-40

Have you check this out as a possible alternative? https://raingler.com/products/2025-newer-toyota-4runner-6th-gen-n500-full-ceiling-attic-net

How are the Radflos performing? I’m considering them (2.5’s) for a mild lift. Thx!

I’m also wondering if an Audiovox backup camera would work up front. Wireless and a 5” monitor.

I think you should try it and let us know! I’m looking for a similar solution

Engine skid plate, Westcott rock rails.

It’s not necessary, but if you’re like me it’ll bug you. You could order the additional one and pick it up at the same time as the rack.

Let us know how the tent performs.

Pic one is an option. There’s two pre-drilled holes on either side of hitch. Pic two is my set up, left side shown

Great! I’d say the ride is factory at 5 psi. Keep in mind I have a 75 lb bike rack attached 95% of the time. Re-inflation, the left bag almost never needs a top off, while the right side I check every couple weeks, and it usually needs a few psi. They really work for leveling and reducing bottom...

It does clear. I think it’s a GPS antenna

I’m liking the factory 3/4 rack. The ARB accessories and hardware pieces are pricey though. That said they do the job. I need to get a propane tank holder and Jerry can or Rotopax holder as well. Those will be $$. Wind noise is minimal and I think it looks great (I also have the Cutting Edge...

This might not apply to your experience, but I’ve noted that sometimes I have to press the brake pedal a bit harder than I think to get it to start. If I haven’t depressed the pedal enough it won’t start.