Search results

I was able to get it out. Thank you very much. I just took a very small screwdriver and pushed the pin in on the one side and was able to get it out. And miraculously I was able to connect to the correct wires looks like that 20 amp wire goes to auxiliary number 2. With these pre-wired...

OK, thanks. And yes, I did see that the larger of the connectors has 20 and 40 amp capability. Do you remember how you were able to remove the caps from those? I can’t seem to get them off and don’t wanna pull too hard on anything. Last thing, when I run the ground wire for my light bar, do I...

How did you remove the caps from those plugs? Also, I need to use the pigtail with the 20-amp connector for my lightbar. Do you happen to know which one I have to plug the harness into?

Sorry to hear that, yeah, my fairing was sitting slightly above the paint, but after realizing that I needed to lift the rack, I was able to create a slightly bigger gap. Obviously, I had to do the same in the back, where the end of the rack was basically rubbing the paint. I have not...

I agree that is the way to make sure the roof rack is not rubbing your paint initially, but what's going to happen when we start putting weight on these things, driving over rough terrain, and they eventually come loose and start to lower again?

I noticed this while installing my low-profile roof rack from them as well. I initially thought I had the brackets set incorrectly, but eventually figured out that I was installing it correctly. I had to lift the fairing and the rear to keep them from rubbing on the paint. Hopefully, they come...

I’i ordered these and am really happy with them. https://ebay.us/m/50htIO

Good info, thanks for letting me know. I saw TRD Jon install a Westcott designs ladder and the liftgate seemed to struggle afterwards so I was planning on changing them. I could have sworn I saw him recommend a replacement but I can’t find the video now.

Has anyone found struts to replace the stock after installing a ladder on the back hatch on a 6th gen?

I saw those. Not a fan of how they sit on the window. Found these on eBay, reasonably priced also. https://ebay.us/m/50htIO

I’m late to the party here, not sure if you ever found any but I got these and they fit great! Super low profile. https://ebay.us/m/50htIO

Does anyone have the door guards installed when they purchased their 4runner? I purchased the Toyota door edge guards for my ORP and they did not come with any directions. They’re very small and don’t even run the entire length of the door. If anyone had them preinstalled when they purchased...

Does anyone have a diagram of where the pre-wired auxiliary switch connectors are in the engine bay? I know there’s one below the windshield washer reservoir that I’ve seen people post about but I’m not sure where the other ones are located and haven’t really seen any good information on that...

Looks great! Are you going to be mass producing these if people want to purchase one?