Recent content by carpartsclemons

Go ahead and order the components for the 5th gen and let us know. New platform you'll have to burn some cash to find out.

No problem

17x8.5 et35 will for easier than 17x8.5 et25. Et35 will sit inboard 10mm. The more poke the harder it is to fit without rubbing (how much depends on each car).

8.5” may rub on the inside. I can’t tell you if they will work or not. But the will poke a bit on the front.

The Trailhunter trim will be more desirable in the future. If you're already have possession of it you should keep the TH.

I test fit a 34 with no lift and it fit. A 35 needs a lift IMO. I am personally only going to run a 1.25" level and a 285/75r17. The westcott or peak collar kit is what I'd grab if you're set on a 35.

You’re welcome. They will be in towards the body 9mm (.345”) more than this. These are 285/75r17 Yokohama Geolamder MTs 17x7.5 et15. No lift.

Yeah you should be good to go.

I'm happy to help but I need the width of the rim not the tire size.

What size is the wheel? 17x?

We need to know the wheel width. Without it offset doesn’t matter.

$729 plus shipping is INSANE for this.

No problem. It can be a lot of work to fit a large tire with minimal lift. Especially if you haven’t done it a bunch of times. A +25 is going to rub at stock height With a 34. That’s just my opinion. +35 would be easier to fit since they would fit inside the wheel wells more. There’s a sweet...

The wheel specs on these are actually +25 NOT +35. +35 would be inbound by 10mm. But that setup will have some poke and rub at factory height. If the wheel didn’t have so much offset it would probably fit...

What wheels are you going to use and what make/model tire 285/75r17 are you wanting to run?