Search results

https://www.alibaba.com/product-detail/Latest-Design-Switch-Panel-System-Universal_1601377951004.html

You might want to extend the rear diff vent . Move it up into the engine bay .

When I had one in my FJ , I never saw more than 14.5 volts .

I just use a blanket . Are you giving away the cover in the link ? That one isn't for a 4Runner . Also Sunday is the 23rd .

I absolutely love mine ! Definitely increases usable space in the back . I have my fridge / freezer slide mounted on it , also my CO2 tank for filling tires . Not a lot of room underneath but room for recovery equipment and hoses for the CO2 tank. Highly recommend . Quality product !

Happens to me also . Happened today while I was sitting at a traffic light , not touching any buttons .

Anybody using this app ? I was using it in my FJ Cruiser and I could get transmission torque converter and pan temps . I can monitor most sensors but not anything to do with the trans .

You could always put a 12v computer fan in there . its all open up into the side panels . No storage but it would provide airflow .

This is what I did in the back of mine . Great product and very useful .

Only the non-hybrid has space under the floor .

Taco Tunes works great and does fit under the drivers seat . You will have to remove seat to hook up the harnesses . You'll need access to the LC2i for tuning. There is space under the rear floor mat for the amp , easy access , 2 10 mm bolts and 3 clips to remove floor .I ran the power cable...

The led lamp only comes on when the lights inside come on . Also has a tilt switch so it only comes on when the hatch is not quite all the way up .

What about using non-ethanol gas . It is 90 octane , just no ethanol . Up here it's 10 cents cheaper per gallon . I run it in my boat with a 454 big block plus lawn mower and small gas motors .

In my FJCruiser , there was a 7.5 Amp fuse that said ALT on it . That's where the voltage booster goes . I did not find the same 7.5 Amp fuse in the 4Runner . Looked at both fuse blocks .Sorry people .

I had the CO2 tank installed in my FJCruiser . I am trying to find somewhere in the back that is strong enough to mount it to . Too much plastic with way to much air space before you find metal . I definitely want to secure it to keep it from flying around ! It is heavy ! I go to Silver Lake...

I installed the CarTrimHome lift gate light . It's one lamp that installs right near the latch . There is a small removable plastic piece there . It ties into the cargo lamp on the drivers side . They supply a harness . I had to cut off the connector to fish the wire through the rubber boot...

I buy a Home furnace filter and cut it to size . Much cheaper !

I have one and will check Tuesday to see if it fits and works .

The other good thing about sliders is less door dings from someone who parks too close and opens their door to far .

I use a couple of shackles to extend where I hook the trailer chains to . https://www.harborfreight.com/34-in-d-ring-shackle-red-58640.html