Search results

Nice printer, good luck. PETG is almost as easy to print as PLA, better in some regards. Less stringing for me and less brittle in use. Made some wire clips for inside another car without problem.

paresthesia here are .stl files gladly for a fellow trash maker!! I'm almost certain these are the final files (sorry for the almost ) I'm always tweaking things so can't give 100%. Hanger is quite tight so very secure for my large volumes of trash. 😂 Not long prints so give it a try and...

This is what I used on my last trip, had white ABS in the printer at that time. Will probably reprint in black after fine tune design (or get a new radio). It accommodates the coax and power lines and just props the radio up about an inch. Needs some tweaks and would only works here because...

Sure. It’s pictured without the “lid”. Works fine without. I’ll dig up files. Of course use ABS or you could try PETG.. I was considering moving it forward and making opening more square. As it is it gets in the way of passenger seat pushed fully forward.

Wow... impressive forethought, discipline and planning… and may you always have an empty passenger floorboard! 🤩 Happy trails Sir.

Just figured out how to edit! Done😎

I have a small 25w VHF/UHF radio that fits in the slot that's behind the trash can pics. The "bracket" holds the radio more secure and higher so I can adjust things. I've made different clips for the mic. on vent and edge of sun roof.. still need some tinkering. I will see if I can take pics...

So where do you put your trash during the day? Best use is on long road trips and multiple day off-road trips, I'd rather have it bagged than bouncing around the cabin. Desert_6Gen, I bow to your end of day tidiness but I'm pretty sure a LOT of folks use trash cans/bags. This would require a...

You paid a few bucks that would've saved me several hours 'perfecting' the design. 😂

Hey, so I am always messing with my 3D printer to solve “problems”. For my Gas T4R ORP... I have a mount for my Ham radio and microphone, inserts for water bottles so they don’t rattle in the door… Attached are Pics of handy passenger side trash can with doggie poop bag. Happy 4Runnin!

Sorry, anyone that was interested, I trashed my oem run in boards off road stupidity! 4R did great otherwise! ‘Restless Off Road Fabrication’ rock sliders now in place… and much needed. 😱

My CarPlay has generally been fine.... however, I occasionally drive a route on highway 4 in the SF east bay and there is a section where CarPlay, bluetooth connection drops and phone has to be reconnected via infotainment 'user' screen... (I need to try the reset trick, thx EL616) This has been...

So far skids and lift.. sliders and roof rack to come. AndreB4R, happy to let you know when sliders installed. Happy 4Runnering!!

BTW, you do need a License just for GMRS too... no test and it covers your entire family.

Agreed. I jump started a hybrid's starter battery with a Lithium-ion device a few years back.. kinda ironic. A must have accessory.

Ditto.. this is a definite head scratch stopper. Thanks @2222CareBearStare

I am also parting with my ORP running boards once I decide in sliders. In the san francisco east bay, let me know.

But it severely affects the approach angle, its gotta go!

Still waiting on my ORP.. can you provide approx. dimensions of the space after seat removal. Thanks

$500 down to secure spot on ORP waiting list. Passed on 2, 3 is gonna be it! ?fully refundable, just to confirm I was serious. $1 below MSRP. Had them remove all the “port installed options” no hassles.