Search results

Can you please post a picture of the red recovery points bolt on under the brush guard mounting post. Thank You

I'd like to install rapter lights on my 4Runner, but I don't want to notch the oem fuse box cover. Is anyone making a replacement cover that can accommodate wiring passing through?

I've noticed a considerabe nose dip when braking. Who make the best shocks for the 6th gen 4Runner with a stock suspension? Thank

I'm looking for recommendations for bump stocks for SR5 with no other suspenion modification. Any assistance would be much appreciated.

The issue with them here in the extreme south of Florida is the engine compartment temp increased 25 degrees.

1600 mile road trip! 98% highway , tire pressure set at 37 pounds, burning 87 octane (Top Tier) . Used the cruise control about 80% of the time and averages 75-83mph. DTE 409

Leave them is awhile and they will fit perfectly

I put the cardboard under the mat and above carpet where you heel rest on the driver side.

Either way I strongly suggest placing a piece of cardboard under the mat. Both are thinner than they use ro be and will wear a spot through your carpet.

I've seen that the bump stop towers for another model are compatable with the 6th Gen 4 Runner. Does anyone happed to know the parts numbers?

I installed one on my 4Runner and didn't have to drop the spare tire

As of today !

Looking for a recommendation for a high temperature Molybdenum-disulfide lithium base chassis grease, which will be used for the slip-yoke. Any suggestions? Thaks Jon

I agree ! I like to take care of my vehicles. Even though I can no longer dabble in the heavy mechanic stuff any more. I find working on my vehicle to be therapy. When I’m not messing around in the garage, you’ll find me fishing for tarpon or snook. So if it’s what you like to do, do it!

I think it's more important to do it between 5-10k just to get rid of the metal particles from the break in, that's just my opinion.

That's crazy! While the transmission has a detailed process you "must" follow.

With an NGL#2 grease with moly being recommended for the drive shaft slip yoke. Would you consider Liqui Moly 3520 LM 47 Long-Life Grease +MoS2 grease a high-quality useable grease? What would you recommend for the spyder joints? I realize a NGL2 Lithium grease is what Toyota calls for. Link...

The transfer calls for 75W. The dealership I talked with said they put the same weight in all three holes. That being said my research found that the transfer case calls for GL-4 and stated that GL-5 has some reacton with yellow metals. However, some say modern GL-5 won't harm yellow...

5.9 quarts

I didn't have to drop the spare and was able to refill the rear directly from the Amsoil bag. However, the front I used the this: https://www.amazon.com/dp/B0GSZ7Z4D5?ref=ppx_yo2ov_dt_b_fed_asin_title Which fit perfectly on the bags.