Recent content by Gagi

Hi everyone Has there been any updates? New products for the molle panel?

The one i printed was 13x13mm if I’m not mistaken.

Thank you

Nice. What are your mounts for Maxtrax ?

I’m thinking to design a new exterior and interior Molle panels and have it made at my cousins shop …

Oh and one more small hack for the head or pillow support. Flip the head rest 😉

Tested the platform at Yosemite National Park Great sleeper. Although if anyone is claustrophobic the height with Los Horizon 4.5 inch thick mattress might be little too less space (I’m totally satisfied how sturdy it was and comfortable) See the photo with sleeping bag attached. The photo is...

I wish I could help. But not planing a trip anytime soon there.

What’s the location? And for how long???

Thanks I didn’t see it. But I called Toyota. That’s how it is.

It’s done see photos above.

Final Update – All Set The bolts I bought from Home Depot had rounded / domed heads, so they wouldn’t seat properly inside the dovetail slots. I ground and flattened the bolt heads so they could slide into the slats and sit flush with custom washers. I fabricated rectangular washers from...

Update: The BASE Rack Narrow Bridge Plate 1780420 did not fit my Maxtrax (model: https://amzn.to/4aKWRik). The spacing comes up short. Even after I enlarged the holes in the plates, the total length is still slightly off. If I mount from the outer ends, it ends up too long. The bolts shown in...

So here are these, done, but i find that the gas pack locs are short (photo red can, just placed not tightened) for 3 gal rotopax, the base height is 2 inches i think it needs to be longer, (just ordered one link below) This one is good with 2 gallon Rotopax. Although the base that is square is...

Thanks Now that have seen your message I realized I didn’t post any photos of the raisers. ill let you know after test hopefully soon. the idea of this is very portable And I forgot to post the photos of raisers. here it is.