Recent content by 6GenChad

OEM Toyota 4Runner all-weather floor mats in good condition. Cleaned and treated with rubber dressing, ready to install. Minor scratches on the middle-row mat from my dog, but otherwise in great shape. Located in San Diego, California.

Damn, I really like the look of those wheels

Even on fire service road, I air down to like 20-23 psi. Makes it a more comfortable ride and better traction if needed.

If I remember correctly, the TH and PRO are a inch higher then factory, but it should be bolt on

It’s a 4Runner, I could care less about MPG 😂😂 I can still pull like 20 if I drive like a grandpa, but if I’m going normally 16-19

I am on 35x12.5R17 Toyo AT3's and it gives a pretty rugged stance. Especially on a +25 offset wheel, it looks mean in the front. All I did was remove the crash support and then trim maybe less than an inch on the bottom of the driver and passenger fender. I am on the same Westcott Lift and don't...

Machined is the only way to go with the blue, just saying

I just ordered some WD rock sliders for the ol’ 6Gen, but was wondering what you guys were running for skid plates and also could use a little help deciding on what to pick. Looking for strength but not trying to break the bank. I don’t go out that much as I’d like due to work, but I’d like to...

My old lab can jump in my passenger seat and that's where she goes. I only take her for night rides to the gas station for snacks

Would Cobb be a better alternative to the OTT Tune? I find Cobb interesting since they've been in the car scene for years.

Oh my bad, I keep thinking this is my thread haha!! Sorry! I’d assume they did

The rear? Unless I get a swing out bumper, then yes. Not sure what you’re talking about

Yes, it’s stated on the website that there will be a slight delay for the lights turning on, also that it loses the function of is gradually turning on and off.

Wow, imagine having 600-700 HP in a 4Runner 😂

Now, question is what happens when you take LT and Portals and put them together? 😉