Search results

I love a side profile shot but boy do I dislike that rake 😖

Not sure if this is helpful but I measured the legs for you. The ones on top are the front legs which are the longest. The ones on bottom are the legs for the middle and rear (same length). Front legs at their shortest and middle/rear legs at their longest Both legs at their longest We have...

+1 for Lasfit. I've never seen or handled the WT liners, so I can't compare. I am very satisfied with my Lasfit liners though. Great coverage. The front mats are flexible enough to go in easy but rigid enough to take out without falling debris everywhere. Easy to clean and they look great.

I chipped a piece of paint off of my roof this weekend while removing the plastic roof rail cover. A piece of plastic, not sharp at all, rubbed a spot of paint right off. Terrible.

Installed my Sherpa Capitol rack today. I absolutely love it.

Yeah. I tested it today. Turned the car on, put the switch on the infinity symbol, then turned it off. Came back out a few hours later and it was still recording.

Can't help there. I only have a front camera. Good luck.

Yellow

Changed out my side mirror covers with paint matched versions. Had to get the Tacoma ones but they fit just fine. I was going to buy the smoked signal lights but now I think I'll pass on those. The OEM light blends fine with the Ice Cap color. In case anyone else wants to do this, Tacoma cover...

Glad I found this thread. Swapped my covers out today and love the look. I was going to buy the smoked signal lights but now I think I'll pass on those. The OEM light blends fine with the Ice Cap color.

I'm in a lot of social media overlanding/car camping spaces and I don't think one exists. Deepsleep Overland makes the type of thing you might want, but they don't currently have an option for the 6th gen according to their site (I also spoke a rep of theirs who was at Overland Expo in OC, CA...

I highly recommend getting a trim tool to help. This pic isn't my exact kit but the tool I used is just like the bottom right one shown in the pic. Very wide. I used the hook end to get in on the front side and pull it down. Be firm but don't try to break it.

Today I installed my Vantrue dash cam and the @Dongar Pro adapter. Realizing I had a wide, hooked trim tool saved the day. My fingers got wrecked trying to pull the dome light module out by hand.

I just installed my dash cam today with the Dongar PMA-01 kit. Assuming the 2026 is the same as 2025, the connector you're looking for is next to the dome light module, not the mirror. Check out these videos. (just reference this for how to remove dome light module) Fair warning: these...

Nice build. Love those wheels. The bronze looks great with Everest.

Ice Cap here. Paint looks excellent at 3500 miles. I don't have a garage or covered parking so I'm really trying to take care of it. Got a ceramic coat applied two weeks after bringing it home. Detailed professionally every 4–6 weeks. Will pop into a touchless car wash if it's really dirty in...

The most noticeable difference is at cold start. It's def louder than before but not obnoxious by any means. Once the idle settles it's barely different from stock. Under acceleration, from in the cabin, it's sliiiightly louder and the overall tone has a deeper, throat-y quality (sorry, couldn't...

That's too much poke for me personally. I like the 20ish offset range most brands are doing for the current gen Tacoma and 4R. I'd also be wary given that the site says the wheel weight is "not available." Do they not make and/or sell the wheels? Why don't they know how much they weight? If...

Based on my experience I would. I have not personally had any damage to my windows or tint when using in channel visors. However, if the windows were really dirty — say with a layer of dried dirt/mud from off roading — and you rolled them up without cleaning them first, I could see the potential...

Installed my trail pipe this morning. Love the improved clearance and clean look of the rear now.