Search results

I only trimmed off the 2 existing tabs on each side so 4 total tabs. They are left over after pushing the liner forward.

Sent you a direct message.

Thank ya!

Yeah I used the extended. They don’t look extended at all so I’d hate to see what the non-extended looks like.

https://a.co/d/dFQsqyL

All the emblems I have. Also a few interior trim rings that go around the climate control and drive mode selector.

Westcott Preload collar lift Method 703 Matte Black 17x8.5 +35 offset 35x12.50r17 Toyo Open Country AT3 (C load) See full mods list at original build thread: https://www.4runner6g.com/forum/threads/panda-2-0-trd-orp-build.6470/

Panda 2.0 has been completed. Westcott Preload collar lift. Method 703 Matte Black 17x8.5 +35 offset 35x12.50r17 Toyo Open Country AT3 (C load) ARB 2.5m awning Lasfit LED turn signals Lasfit cargo liners for the rear seat backs Factory Toyota Red recovery hooks (front) 3D printed goodies here...

Pro offers more options even the Off Road Premium doesn't have available. Power fold mirrors, Sway Bar disconnect, cool interior, cool grill, etc. TRD Pro isn't just about the Fox suspension.

What is your measurement from center of the axle to the bottom of the fender on the rear? I didn't premeasure mine but afterwards it was 22". I referenced Westcott's video on the factory measurements and their non-hybrid measured 22" stock. So a 3/4" lift on a hybrid only gets it to stock...

Got Matte Black 703's, the same tires as you (C loads), and the Westcott lift. All should be here by this weekend. Your rig is slick!

Where did you get your Volks from?

Any negative effects on MPGs on the hybrid models? I know I know, its a 4runner, MPGs don't matter. Well, when they are low to begin with, we don't need them any lower 😅