-
šš»āļø 2025-2026 4Runner Owners (Delivered) List: š Add Yours Here!
š 2025-2026 4Runner Allocations List (Nationwide): š See The Daily Updated List Inside!
Sponsored
JCP's latest activity
-
JCP reacted to AdFour's post in the thread Skid Plates Part Numbers - Rear differential skid plate + front & transfer case skid install with
Like.
Guide to install all skid plates specifically rear diff. Rear diff is the hardest of the 3. The front 2 are pretty simple bolt on... -
JCP reacted to AdFour's post in the thread Skid Plates Part Numbers - Rear differential skid plate + front & transfer case skid install with Like.
Yes, not needed. Edit, I've consolidated everything up top, easier for the reader.. Will update if I find anything new
-
JCP replied to the thread +35 offset wheels photos.I appreciate your detailed postā¦Been spending way too much time debating the same thing. Going with the 35 offset!
-
I joined the +35 club. Fretted over +25 or +35. For a while. I didnāt want the thread to stick out because Iām driving dirt road daily...
-
JCP reacted to CorvinoTRDPRO's post in the thread 2026 4Runner TRD ORP Build on 35" Toyo Open Country ATIII Tires & Method Wheels w/ Diode Lighting, AWE 0FG Exhaust + Westcott Lift with Like.
Wha exactly did you have to do to get those 35s to fit? Crash played, mud flaps and pin felt? Plus any trimming / viper cut? thinking... -
JCP reacted to Josalbrec6G's post in the thread 5W-30 for hot climates? 0W-20 for cold climates? with Like.
This is the comparison video using oil analysis comparison before 10k miles and after. The content created was the oil specialist for...
-
JCP replied to the thread Sound deadening insulation project.Curious, how did cutting a hole in the carpet for the amp quiet the engine noise? Was the carpet lifted up by the amp or something...
-
Same thing on my TH. No issue with water or dust yet.
-
JCP replied to the thread Rear corner window loose / flex.Were you able to get any info from Toyota?
-
JCP replied to the thread Rear corner window loose / flex.I noticed both driver and passenger sides loose. What the hell. Anyone take it to the dealer yet? I may have time this Friday or...
-
JCP replied to the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!!.šš¼ I like it -
Wait until Memorial Day. The oil then comes up to $27 per six quart box and the filter is like $4. The cheapest OEM oil change for your...
-
JCP reacted to Franco's post in the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!! with Like.
No probably out past the fender by 3/4 inch
-
JCP replied to the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!!.All good! It does help knowing the tread sticks out about 1". Would you say the lip of the wheel lines up with the fender?
-
JCP replied to the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!!.With the wheel offset +12 do the wheels line up with the fender, or do they poke a bit?
-
JCP replied to the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!!.Do you mind posting photos of the tire poke? I'm considering offsets 25 and 12 since these are so light!
-
I have the F133N. Holds better the drain tubing. Still plenty of room above the skid plate. F133S works great too. It has a shorter...
-
JCP reacted to onlywayman's post in the thread What did you do to your 6th Gen 4Runner today?? šØš»āš§ š§° š with Like.
It was the only one AutoZone had and the short nipple will still handle a hose
-
JCP reacted to drNick's post in the thread Recommended engine break-in and oil change frequency + factory oil analysis test (by Motor Oil Geek) with Like.
āThe Motor Oil Geekā Lake posted today a video describing the proper, according to him, break-in oil change protocol for the Toyota 2.4...
-
I just went to the website to check. There wasn't a hybrid option available, so I just went with the 2.4 4-cyl option and got 4...
-
JCP replied to the thread Fumoto Oil Drain Valve for 6th gen 4Runner?.Hi, which size did you end up getting? Maybe it's the same as the 5th gen, but not 100%. The website only has options up to 2024. Edit...
-
JCP reacted to BadTrainDriver's post in the thread Fumoto Oil Drain Valve for 6th gen 4Runner? with Like.
I've been a Fumoto valve fan for better than two decades but switched to the ValvoMax for my last few vehicles. Either one is a quality...
-
JCP replied to the thread What did you do to your 6th Gen 4Runner today?? šØš»āš§ š§° š .Nice. I'm considering the Fumoto valve and debating the short or long nipple. During the install was there enough room for the long...
-
JCP reacted to refone's post in the thread 40% Sale on TRD OEM parts from Toyota (+ free shipping) with Like.
I purchased five wheels and TRD Pro mudguards for a very low price.
-
JCP replied to the thread Xpel or Ceramic Pro Kavaca.
-
-
JCP reacted to sstarrx2's post in the thread OEM Toyota All Weather Floor Liners Mats Installed with Like.
Well....not my photos, but I do have these in my truck and it does lay flat after a bit of time. These look fresh out of the box.
-
JCP replied to the thread OEM Toyota All Weather Floor Liners Mats Installed.That and in your photos the middle hump doesn't look flat on to the carpet
-
JCP replied to the thread OEM Toyota All Weather Floor Liners Mats Installed.Does not go over the hump
-
JCP replied to the thread OEM Toyota All Weather Floor Liners Mats Installed.My off-road premium has all weather mats, but my rear mats have two pieces. Strange.
-
JCP replied to the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!!.Man, that OCD tendency is what's driving me to spend the extra $$$ for the MT64š Which coilover set are you checking out?
-
JCP replied to the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!!.Thank you, that helps a great deal! Thatās awesome your MPGs actually went up! As for lift, Iām not a heavy off roader like rock...
-
JCP replied to the thread Xpel or Ceramic Pro Kavaca.Ah right, my ride is at the shop getting tinted. I'll post pics when it's done.. Thank y'all! Xpel XR Plus 15% front doors 20% rear...
-
JCP replied to the thread 2025 Underground 4Runner TRD Off-Road Build - Time to Enjoy!!!.Dude it looks great. I just bought a black ORP and shopping for lift, wheels and tires. I dig the light weight setup you have. Did it...
-
JCP replied to the thread Why go with 17" wheels over factory 18" wheels?.Yup and 17's are generally lighter
-
JCP replied to the thread BLACK Photos 4Runner 6th Gen (2025+).Thanks. Going with Xpel Plus ceramicā¦Leaning towards 20% rears and 15% front doors. Windshield 45% and moon 35% are good to go. -
JCP reacted to dirtwheeler's post in the thread ReadyLift 2.5" SST lift, 17x8.5 +35 Method 703 wheels, and BFG KO3 LT285/75R17 tires with Like.
No tinting. Just factory. They were going to try to throw in tinting and charge me for it. Standard dealership shenanigans. I prefer to... -
JCP replied to the thread BLACK Photos 4Runner 6th Gen (2025+).What tint levels did you go with? Ceramic? Really like the bronze on the front doorā¦
-
JCP replied to the thread BLACK Photos 4Runner 6th Gen (2025+).Looking good man, what tint levels did you go with? I'm about to do mine with xpel xr plus ceramic and debating on 15 or 20%
-
JCP replied to the thread Xpel or Ceramic Pro Kavaca.Do you think they installed a lighter shade in the back to match the 20% front doors?
-
JCP reacted to Sacul40's post in the thread Window Tint installed (Ceramic XPEL Prime XR) - 15% front / 20% rear with Like.
Getting it next month. -
JCP replied to the thread Everest TRD ORP with PPF, Tint, and Ceramic Coating!.70% in the back looks pretty dark. Wondering if it's because of the reflection. How well can you see inside? Do you have any photos of... -
JCP replied to the thread Just Added 15% Tint All The Way Around.Looking clean. I'm trying to decide between 20% or 15%, do you have more photos? Did you go with ceramic or regular? -
JCP replied to the thread Window Tint installed (Ceramic XPEL Prime XR) - 15% front / 20% rear.Did you end up tinting that Pro?
-
JCP replied to the thread Xpel or Ceramic Pro Kavaca.I'd say very well. Thanks for posting this photo, it really helps!
-
XR Plus
-
Mine is XR Black
-
JCP replied to the thread Xpel or Ceramic Pro Kavaca.Which Xpel tint did you go with?
-
I was surprised they didnāt look darker as well. Iām happy with how it came out
-
JCP replied to the thread Xpel or Ceramic Pro Kavaca.Looks really good. I'm surprised the back windows don't look darker with 20% over the factory dye
-
