Recent content by IsGon26

already posted... https://www.4runner6g.com/forum/threads/41-22-kill-switch-on-a-2025-4runner-hybrid.10099/page-2#post-123822

I installed, and it works, on my 2026 TRD ORP Hybrid, there are 2 diferent relays that come in the package, try both.

Cali Raised rack, installed with help of a friend. Difficulty was the height as we are both about 5'8", just used plumbing pipe foam tubes at all edges to get into position, otherwise it would have scratched roof.

Topo map Lines by Wraplander (not a paid ad, I purchased on my own) Just applied, will update after upcoming dirt road trip if they hold up.

Finally got my latest upgrade to get some real dirt on this thing, BFGoodrich K03. So far I'm happy with the minimal noise level increase. My perception is the K03 has a tighter steering control than the OEMs. So far upgrades include: BFGoodrich K03 165/70R18-119 Nano Ceramic Tint (70% to block...

heres the youtube, detailed removal of DECK TRIM SIDE PANEL ASSEMBLY

Not knocking Costco, just stating my experience: last time I used they discount program (2023) the dealer added a "requirement" of security protection package including some brick-sized GPS (mostly battery) tracker for almost half that $4k savings. The first two times I used the program it was...

Yes, it’s just a wind noise reducer, I’m sure some road sound too but it’s a small gap between the doors.

I followed advice, while not dramatic it does make a difference, gasket is also a perfect fit, just trim almost 3". Thanks for this great tip!

I live in the Midwest, my only real use is the remote start, which really helps when its subzero outside. Otherwise I use CarPlay.

First 1,000 miles avg 18.6 in the metro Chicago area. I got i think 16+/- on my previous Gen5 and over 22 when i drove out west.

Yes, its marked on the lid as ST No issues whatsoever, here are a few pictures. I might add a dab of silicon just for safety, but the holes i made the wires went in very snug.

Installed wireless version on my 2026 trd orp hybrid this weekend. Power from passenger side under hood fuse box, relay on driver side fuse box. Both boxes are soft plastic, so i drilled tiny holes close to the base where fuses lie out toward rear of vehicle. Cut the+ wire and slid through then...