Lost one screw. My solution for now. Remove the speed nuts and through bolted. Speed nuts that take a machine screw would hold better. I don’t like how the existing hardware starts to pierce through the plastic. Used fender washers to spread the load. If I find the energy, hit them with a paint...
I use the factory’s recommended tire pressure as a baseline. I let my tires tell me how much to inflate. Pay attention to the wear on the tires. I drive everything like a car. Fronts generally wear on the outside due to cornering. Rears tend to wear the center. I anticipate a little more air in...
A license plate is a little too tall. I‘m considering a couple rivnuts on the bottom side of the sub bumper. There’s a little access. I will have to fab a bracket.
You should be more worried about a vehicle running hotter in city/stop and go, than highway driving. The oil is cooled pretty well. You shouldn’t have any issues unless you just pulled into the driveway after running from the cops
Break squeal is caused by vibration. Think of a chair and that annoying noise dragging across a floor. It’s harmless. Most likely caused by the haze of rust that builds up on the rotor face. I back in everywhere. I have yet to experience it.
Yes and yes. I assume the pop is just the latch. My window sticks up a little on the right side when rolled down. The roll down window is unnecessary in my opinion.
Toyota makes some very stupid design decisions at times. It would have been a lot more comfortable for 2nd row passengers if they moved the seats back just a few more inches.